The Varian line of Low Power RF Amplifiers has been designed fo rgeneral purpose
laboratory test and measuring applications. Rated powers of 10 watts and 20 watts
are offered over the frequency range of 100 MHz to 26.5 GHz.
Primary power is 115 Vac, single phase, 50/60 Hz. 100 or 230 Vax mains power operation
is optionally available. The high efficiency power supply designs provide the minimum
power consumption possible. High filtering and regulation insure performance within
all specifications over a wide range of environmental and operating conditions.
|
Model |
Power (Watts) |
Frequency |
Gain (dB) |
O/P |
| VZL6941K1 |
20 |
1.0 - 2.0 |
35 |
N |
|
General Specs. |
||||
| Impedance: | 50 ohms nominal | |||
| VSWR: | Input: | 2.0:1 typical | ||
| Output: | 2.0:1 typical | |||
| Load: | 1.3:1 max. for full spec compliance. 2.0:1 mas for no damage. | |||
| Noise & Spurious: | -50 dBc typical excluding harmonics and residual modulation. | |||
| Residual AM: | -40 dBc | |||
| Residual FM: | Less than 4 kHz peak-to-peak in any 5 MHz band. | |||
| AM/PM Conversion: | 2.5 /dB typical at 6 dB below rated output | |||
| Noise Figure: | 35 dB max. for L-Band and above | |||
| Harmonic Content: | -3 dBc at lower band edge decreasing to -15 dBc (typical) at upper band edge without
optional harmonic filter. -20 dBc for P-Band models. |
|||
| Dimension: | 3.5 x 19 x 19.25 inches L-Band and above 7 x 19 x 18.1 inches P-band models |
|||
| Option A - Input Isolator | ||||
| Option D - Output Isolator | ||||
Test Equipment
Corporation.For more information E-Mail sales@testeq.com or call (800)TEC-DOES.
Return to Test Equipment Corporation's Main Page